Publications

Refine Results

(Filters Applied) Clear All

Adaptive optics wavefront sensors based on photon-counting detector arrays

Published in:
Proc. SPIE Vol. 7736, Adaptive Optics Systems II, 27 June 2010, 773610.

Summary

For adaptive optics systems, there is a growing demand for wavefront sensors that operate at higher frame rates and with more pixels while maintaining low readout noise. Lincoln Laboratory has been investigating Geiger·mode avalanche photodiode arrays integrated with CMOS readout circuits as a potential solution. This type of sensor counts photons digitally within the pixel, enabling data to be read out at high rates without the penalty of readout noise. After a brief overview of adaptive optics sensor development at Lincoln Laboratory, we will present the status of silicon Geiger· mode·APD technology along with future plans to improve performance.
READ LESS

Summary

For adaptive optics systems, there is a growing demand for wavefront sensors that operate at higher frame rates and with more pixels while maintaining low readout noise. Lincoln Laboratory has been investigating Geiger·mode avalanche photodiode arrays integrated with CMOS readout circuits as a potential solution. This type of sensor counts...

READ MORE

Hybridization process for back-illuminated silicon Geiger-mode avalanche photodiode arrays

Published in:
SPIE Vol. 7681, Advanced Photon Counting Techniques IV, 5 April 2010, 76810P.

Summary

We present a unique hybridization process that permits high-performance back-illuminated silicon Geiger-mode avalanche photodiodes (GM-APDs) to be bonded to custom CMOS readout integrated circuits (ROICs) - a hybridization approach that enables independent optimization of the GM-APD arrays and the ROICs. The process includes oxide bonding of silicon GM-APD arrays to a transparent support substrate followed by indium bump bonding of this layer to a signal-processing ROIC. This hybrid detector approach can be used to fabricate imagers with high-fill-factor pixels and enhanced quantum efficiency in the near infrared as well as large-pixel-count, small-pixel-pitch arrays with pixel-level signal processing. In addition, the oxide bonding is compatible with high-temperature processing steps that can be used to lower dark current and improve optical response in the ultraviolet.
READ LESS

Summary

We present a unique hybridization process that permits high-performance back-illuminated silicon Geiger-mode avalanche photodiodes (GM-APDs) to be bonded to custom CMOS readout integrated circuits (ROICs) - a hybridization approach that enables independent optimization of the GM-APD arrays and the ROICs. The process includes oxide bonding of silicon GM-APD arrays to...

READ MORE

Operation and optimization of silicon-diode-based optical modulators

Published in:
IEEE J. Sel. Top. in Quantum Electron., Vol. 16, No. 1, January/February 2010, pp. 165-172.

Summary

An optical modulator in silicon based on a diode structure has been operated in both forward and reverse bias. This modulator achieves near state-of-the-art performance in both modes, thereby making this device idea for comparing the two modes of operation. In reverse bias, the device has a V[pi]L of 4.9 V-cm and a bandwidth of 26GHz. In forward bias, the device is very sensitive, a V[pi]L a slow as 0.0025 V-cm has been achieved, but the bandwidth is only 100 MHz. A ndw geometyr for a reverse-bias device is proposed, and it is predicted to achieve a V[pi]L of 0.5V.cm.
READ LESS

Summary

An optical modulator in silicon based on a diode structure has been operated in both forward and reverse bias. This modulator achieves near state-of-the-art performance in both modes, thereby making this device idea for comparing the two modes of operation. In reverse bias, the device has a V[pi]L of 4.9...

READ MORE

Organometallic vapor phase epitaxy of relaxed InPAs/InP as multiplication layers for avalanche photodiodes

Published in:
J. Cryst. Growth, Vol. 310, No. 7-9, April 2008, pp. 1583-1589 (Proc. 13th Int. Conf. on Crystal Growth, in conjunction with Int. Conf. on Vapor Growth and Epitaxy and US Biennial Workshop on Organometallic Vapor Phase Epitaxy, 12-17 August 2007).
Topic:

Summary

InP1-yAsy epitaxial layers grown lattice-mismatched (LMM) on InP substrates were investigated as a new materials system for multiplication layers in Geiger-mode avalanche photodiodes (GM APDs) for detection of photons in the range 1.6-2.5 mm. LMM InP1-yAsy epilayers were grown on semi-insulating (1 0 0) InP substrates misoriented 0.2 and 2 [1 1 0] by organometallic vapor phase epitaxy at a growth temperature of 580 1C. The growth scheme used for the InP1-yAsy buffer layer was optimized based on surface step structure and X-ray diffraction. It was found that step-flow growth is a minimum criterion for obtaining good material quality. A narrower XRD full-width at half-maximum values were measured for 21-miscut substrates compared to 0.21-miscut substrates. A highquality buffer was obtained by step-grading the InP1-yAsy composition in increments of y = 0.05 over a layer thickness of 0.5 mm to a final y = 0.25. The device performance of LMM GM APDs was compared to that of measured more traditional lattice-matched GaSbbased devices. At 77 K, dark count rates of LMM devices are ~50 kHz at 5V overbias, and are comparable to GaSb-based p-i-n diodes operated in Geiger mode, while reset times of 0.02 ms are approximately 3 orders of magnitude lower than GaSb-based GM APDs.
READ LESS

Summary

InP1-yAsy epitaxial layers grown lattice-mismatched (LMM) on InP substrates were investigated as a new materials system for multiplication layers in Geiger-mode avalanche photodiodes (GM APDs) for detection of photons in the range 1.6-2.5 mm. LMM InP1-yAsy epilayers were grown on semi-insulating (1 0 0) InP substrates misoriented 0.2 and 2...

READ MORE

Experimental demonstration of remote optical detection of trace explosives.

Published in:
SPIE Vol. 6954, Chemical, Biologica, Radiological, Nuclear and Explosives (CBRNE) Sensing IX, 18-20 March 2008, 695407.

Summary

MIT Lincoln Laboratory has developed a concept that could enable remote (10s of meters) detection of trace explosives' residues via a field-portable laser system. The technique relies upon laser-induced photodissociation of nitro-bearing explosives into vibrationally excited nitric oxide (NO) fragments. Subsequent optical probing of the first vibrationally excited state at 236 nm yields narrowband fluorescence at the shorter wavelength of 226 nm. With proper optical filtering, these photons provide a highly sensitive explosives signature that is not susceptible to interference from traditional optical clutter sources (e.g., red-shifted fluorescence). Quantitative measurements of trace residues of TNT have been performed demonstrating this technique using a breadboard system, which relies upon a pulsed optical parametric oscillator (OPO) based laser. Based on these results, performance projections for a fieldable system are made.
READ LESS

Summary

MIT Lincoln Laboratory has developed a concept that could enable remote (10s of meters) detection of trace explosives' residues via a field-portable laser system. The technique relies upon laser-induced photodissociation of nitro-bearing explosives into vibrationally excited nitric oxide (NO) fragments. Subsequent optical probing of the first vibrationally excited state at...

READ MORE

Design of an optical photon counting array receiver system for deep-space communications

Summary

Demand for increased capacity in deep-space to Earth communications systems continues to rise as sensor data rates climb and mission requirements expand. Optical freespace laser communications systems offer the potential for operating at data rates 10 to 1000 times that of current radiofrequency systems. A key element in an optical communications system is the Earth receiver. This paper reviews the design of a distributed photon-counting receiver array composed of four meter-class telescopes, developed as a part of the Mars Laser Communications Demonstration (MLCD) project. This design offers a cost-effective and adaptable alternative approach to traditional large, single-aperture receive elements while preserving the expected improvement in data rates enabled by free-space laser communications systems. Key challenges in developing distributed receivers and details of the MLCD design are discussed.
READ LESS

Summary

Demand for increased capacity in deep-space to Earth communications systems continues to rise as sensor data rates climb and mission requirements expand. Optical freespace laser communications systems offer the potential for operating at data rates 10 to 1000 times that of current radiofrequency systems. A key element in an optical...

READ MORE

Arrays of InP-based avalanche photodiodes for photon counting

Summary

Arrays of InP-based avalanche photodiodes (APDs) with InGaAsP absorber regions have been fabricated and characterized in the Geiger mode for photon-counting applications. Measurements of APDs with InGaAsP absorbers optimized for 1.06 um wavelength show dark count rates (DCRs)
READ LESS

Summary

Arrays of InP-based avalanche photodiodes (APDs) with InGaAsP absorber regions have been fabricated and characterized in the Geiger mode for photon-counting applications. Measurements of APDs with InGaAsP absorbers optimized for 1.06 um wavelength show dark count rates (DCRs)

READ MORE

An end-to-end demonstration of a receiver array based free-space photon counting communications link

Published in:
SPIE Vol. 6304, Free-Space Laser Communications VI, 13-17 August 2006, pp. 63040H-1 - 63040H-13.

Summary

NASA anticipates a significant demand for long-haul communications service from deep-space to Earth in the near future. To address this need, a substantial effort has been invested in developing a free-space laser communications system that can be operated at data rates that are 10-1000 times higher than current RF systems. We have built an endto- end free-space photon counting testbed to demonstrate many of the key technologies required for a deep space optical receiver. The testbed consists of two independent receivers, each using a Geiger-mode avalanche photodiode detector array. A hardware aggregator combines the photon arrivals from the two receivers and the aggregated photon stream is decoded in real time with a hardware turbo decoder. We have demonstrated signal acquisition, clock synchronization, and error free communications at data rates up to 14 million bits per second while operating within 1 dB of the channel capacity with an efficiency of greater than 1 bit per incident photon.
READ LESS

Summary

NASA anticipates a significant demand for long-haul communications service from deep-space to Earth in the near future. To address this need, a substantial effort has been invested in developing a free-space laser communications system that can be operated at data rates that are 10-1000 times higher than current RF systems...

READ MORE

Afterpulsing in Geiger-mode avalanche photodiodes for 1.06um wavelength

Summary

We consider the phenomenon of afterpulsing in avalanche photodiodes (APDs) operating in gated and free-running Geiger mode. An operational model of afterpulsing and other noise characteristics of APDs predicts the noise behavior observed in the free-running mode. We also use gated-mode data to investigate possible sources of afterpulsing in these devices. For 30-um-diam, 1.06-um-wavelength InGaAsP/InP APDs operated at 290 K and 4 V overbias, we obtained a dominant trap lifetime of td=0.32 us, a trap energy of 0.11 eV, and a baseline dark count rate 245 kHz.
READ LESS

Summary

We consider the phenomenon of afterpulsing in avalanche photodiodes (APDs) operating in gated and free-running Geiger mode. An operational model of afterpulsing and other noise characteristics of APDs predicts the noise behavior observed in the free-running mode. We also use gated-mode data to investigate possible sources of afterpulsing in these...

READ MORE

Geiger-mode avalanche photodiodes for three-dimensional imaging

Published in:
Lincoln Laboratory Journal, Vol. 13, No. 2, 2002, pp. 335-350.

Summary

We discuss the properties of Geiger-mode avalanche photodiodes (APDs) and their use in developing an imaging laser radar (ladar). This type of photodetector gives a fast electrical pulse in response to the detection of even a single photon, allowing for sub-nsec-precision photon-flight-time measurement. We present ongoing work at Lincoln Laboratory on three-dimensional (3D) imaging with arrays of these diodes, and the integration of the arrays with fast complementary metal-oxide semiconductor (CMOS) digital timing circuits.
READ LESS

Summary

We discuss the properties of Geiger-mode avalanche photodiodes (APDs) and their use in developing an imaging laser radar (ladar). This type of photodetector gives a fast electrical pulse in response to the detection of even a single photon, allowing for sub-nsec-precision photon-flight-time measurement. We present ongoing work at Lincoln Laboratory...

READ MORE