Publications

Refine Results

(Filters Applied) Clear All

Optical down-sampling of wide-band microwave signals

Published in:
J. Lightwave Technol., Vol. 21, No. 12, December 2003, pp. 3116-3124.

Summary

Phase-encoded optical sampling allows radio-frequency and microwave signals to be directly down-converted and digitized with high linearity and greater than 60-dB (10-effective-bit) signal-to-noise ratio. Wide-band electrical signals can be processed using relatively low optical sampling rates provided that the instantaneous signal bandwidth is less than the Nyquist sampling bandwidth. We demonstrate the capabilities of this technique by using a 60-MS/s system to down-sample two different FM chirp signals: 1) a baseband (0-250 MHz) linear-chirp waveform and 2) a nonlinear-chirp waveform having a 10-GHz center frequency and a frequency excursion of 1 GHz. We characterize the frequency response of the technique and quantify the analog bandwidth limitation due to the optical pulse width. The 3-dB bandwidth imposed by a 30-ps sampling pulse is shown to be 10.4 GHz. We also investigate the impact of the pulse width on the linearity of the phase-encoded optical sampling technique when it is used to sample high-frequency signals.
READ LESS

Summary

Phase-encoded optical sampling allows radio-frequency and microwave signals to be directly down-converted and digitized with high linearity and greater than 60-dB (10-effective-bit) signal-to-noise ratio. Wide-band electrical signals can be processed using relatively low optical sampling rates provided that the instantaneous signal bandwidth is less than the Nyquist sampling bandwidth. We...

READ MORE

Optically sampled analog-to-digital converters

Published in:
IEEE Trans. Microw. Theory Tech., Vol. 49, No. 10, October 2001, pp. 1840-1853.
Topic:

Summary

Optically sampled analog-to-digital converters (ADCs) combine optical sampling with electronic quantization to enhance the performance of electronic ADCs. In this paper, we review the prior and current work in this field, and then describe our efforts to develop and extend the bandwidth of a linearized sampling technique referred to as phase-encoded optical sampling. The technique uses a dual-output electrooptic sampling transducer to achieve both high linearity and 60-dB suppression of laser amplitude noise. The bandwidth of the technique is extended by optically distributing the post-sampling pulses to an array of time-interleaved electronic quantizers. We report on the performance of a 505-MS/s (megasample per second) optically sampled ADC that includes high-extinction LiNbO(3) 1-to-8 optical time-division demultiplexers. Initial characterization of the 505-MS/s system reveals a maximum signal-to-noise ratio of 51 dB (8.2 bits) and a spur-free dynamic range of 61 dB. The performance of the present system is limited by electronic quantizer noise, photodiode saturation, and preliminary calibration procedures. None of these fundamentally limit this sampling approach, which should enable multigigahertz converters with 12-b resolution. A signal-to-noise analysis of the phase-encoded sampling technique shows good agreement with measured data from the 505-MS/s system.
READ LESS

Summary

Optically sampled analog-to-digital converters (ADCs) combine optical sampling with electronic quantization to enhance the performance of electronic ADCs. In this paper, we review the prior and current work in this field, and then describe our efforts to develop and extend the bandwidth of a linearized sampling technique referred to as...

READ MORE

Showing Results

1-2 of 2