Publications

Refine Results

(Filters Applied) Clear All

Four-tap RF canceller evaluation for indoor in-band full-duplex wireless operation

Published in:
IEEE Radio and Wireless Symp., RWS 2017, 15-18 January 2017.
Topic:
R&D group:

Summary

Analog self-interference mitigation techniques are currently being investigated in a variety of operational settings for In-Band Full-Duplex (IBFD) systems. The significant multipath effects of realistic environments, such as inside buildings, can severely limit performance. The influence of different transceiver parameters on the effectiveness of a four-tap RF canceller using a tapped delay line architecture was characterized with a set of indoor measurements. The prototype canceller yielded up to 30 dB of cancellation over bandwidths ranging from 10 to 120 MHz centered at 2.45 GHz, and produced a combined analog system isolation that reached above 85 dB.
READ LESS

Summary

Analog self-interference mitigation techniques are currently being investigated in a variety of operational settings for In-Band Full-Duplex (IBFD) systems. The significant multipath effects of realistic environments, such as inside buildings, can severely limit performance. The influence of different transceiver parameters on the effectiveness of a four-tap RF canceller using a...

READ MORE

Covariance estimation in terms of Stokes parameters with application to vector sensor imaging

Published in:
2016 Asilomar Conf. on Signals, Systems and Computers, Asilomar 2016, 6-9 November 2016.

Summary

Vector sensor imaging presents a challenging problem in covariance estimation when allowing arbitrarily polarized sources. We propose a Stokes parameter representation of the source covariance matrix which is both qualitatively and computationally convenient. Using this formulation, we adapt the proximal gradient and expectation maximization (EM) algorithms and apply them in multiple variants to the maximum likelihood and least squares problems. We also show how EM can be cast as gradient descent on the Riemannian manifold of positive definite matrices, enabling a new accelerated EM algorithm. Finally, we demonstrate the benefits of the proximal gradient approach through comparison of convergence results from simulated data.
READ LESS

Summary

Vector sensor imaging presents a challenging problem in covariance estimation when allowing arbitrarily polarized sources. We propose a Stokes parameter representation of the source covariance matrix which is both qualitatively and computationally convenient. Using this formulation, we adapt the proximal gradient and expectation maximization (EM) algorithms and apply them in...

READ MORE

Nonlinear equalization of microwave photonic links

Published in:
IEEE Int. Topical Meeting on Microwave Photonics, MWP 2016, 31 October - 3 November 2016.

Summary

High dynamic range is a key requirement in advanced microwave photonic systems. We demonstrate compensation of nonlinearities occurring in microwave photonic links using a novel digital nonlinear equalization technique and demonstrate suppression of distortion products by 33 dB with a small number of equalizer coefficients.
READ LESS

Summary

High dynamic range is a key requirement in advanced microwave photonic systems. We demonstrate compensation of nonlinearities occurring in microwave photonic links using a novel digital nonlinear equalization technique and demonstrate suppression of distortion products by 33 dB with a small number of equalizer coefficients.

READ MORE

3D printed conformal array antenna: simulations and measurements

Summary

A conformal array antenna has been investigated using a combination of 3D printer and copper plating techniques. Circular patch antenna elements were copper plated onto a 3D printed dielectric substrate made of ABS-M30 material. Measured and simulated element reflection coefficient, element gain patterns, and array scanned beam radiation patterns at L band are in good agreement.
READ LESS

Summary

A conformal array antenna has been investigated using a combination of 3D printer and copper plating techniques. Circular patch antenna elements were copper plated onto a 3D printed dielectric substrate made of ABS-M30 material. Measured and simulated element reflection coefficient, element gain patterns, and array scanned beam radiation patterns at...

READ MORE

Aperture PCB assemblies: transition to production ready designs

Published in:
6th Int. Symp. on Phased Array Systems and Technology, PAST 2016, 18-21 October 2016.
Topic:
R&D group:

Summary

MACOM designed the initial radar panels for the next generation surveillance radar with limited funds, with the philosophy that the initial design would be kept as simple as possible and that incremental improvements would be made as the program progressed, with the intent of having a tile assembly that is easy to manufacture by the first build of a larger radar (approximately 80 panels). The design is now being updated for an 80 panel order with the goal of optimizing the design electrically, for assembly and for test. This paper will discuss both the design, assembly, packaging, and test updates that are being made to have a board and board assembly that is easy to manufacture and test, with the goal of keeping cost as low as possible. These techniques will not only be used for the MPAR tiles, but also for tiles that are currently being developed for other programs.
READ LESS

Summary

MACOM designed the initial radar panels for the next generation surveillance radar with limited funds, with the philosophy that the initial design would be kept as simple as possible and that incremental improvements would be made as the program progressed, with the intent of having a tile assembly that is...

READ MORE

Design and analysis of an axisymmetric phased array fed Gregorian reflector system for limited scanning

Author:
Published in:
6th Int. Symp. on Phased Array Systems and Technology, PAST 2016, 18-21 October 2016.
Topic:
R&D group:

Summary

An axisymmetric phased array fed confocal parabolic Gregorian reflector system is explored. The antenna utilizes a planar phased array located near the vertex of the primary reflector. Numerical electromagnetic simulations based on the multilevel fast multipole method (MLFMM) were used to analyze and optimize the antenna parameters for limited scanning. Simulations of the scanning performance of a dual reflector system with a 2 meter diameter primary reflector operating at Ku band are presented.
READ LESS

Summary

An axisymmetric phased array fed confocal parabolic Gregorian reflector system is explored. The antenna utilizes a planar phased array located near the vertex of the primary reflector. Numerical electromagnetic simulations based on the multilevel fast multipole method (MLFMM) were used to analyze and optimize the antenna parameters for limited scanning...

READ MORE

Development of a high-throughput microwave imaging system for concealed weapons detection

Summary

A video-rate microwave imaging aperture for concealed threat detection can serve as a useful tool in securing crowded, high foot traffic environments. Realization of such a system presents two major technical challenges: 1) implementation of an electrically large antenna array for capture of a moving subject, and 2) fast image reconstruction on cost-effective computing hardware. This paper presents a hardware-efficient multistatic array design to address the former challenge, and a compatible fast imaging technique to address the latter. Prototype hardware which forms a partition of an imaging aperture is discussed. Using this hardware, it is shown that the proposed array design can be used to form high-fidelity 3D images, and that the presented image reconstruction technique can form an image of a human-sized domain in ≤ 0.1s with low cost computing hardware.
READ LESS

Summary

A video-rate microwave imaging aperture for concealed threat detection can serve as a useful tool in securing crowded, high foot traffic environments. Realization of such a system presents two major technical challenges: 1) implementation of an electrically large antenna array for capture of a moving subject, and 2) fast image...

READ MORE

Simultaneous transmit and receive with digital phased arrays

Published in:
6th Int. Symp. on Phased Array Systems and Technology, PAST 2016, 18-21 October 2016.

Summary

A new architecture is proposed for achieving Simultaneous Transmit and Receive (STAR) with a digital phased array. We demonstrate how digital beamforming and cancellation enables adjacent transmitting and receiving sub-arrays to operate simultaneously in the same frequency band without a significant reduction in performance. Our approach uses only digital signal processing techniques and does not require custom radiators or analog cancelling circuits that can increase front-end losses and add significant size, weight and cost to the array. Simulated results are presented for a 50-element array that achieves more than 160 dB of effective isolation between transmit and receive beams over a 100 MHz instantaneous band centered at 2.45 GHz.
READ LESS

Summary

A new architecture is proposed for achieving Simultaneous Transmit and Receive (STAR) with a digital phased array. We demonstrate how digital beamforming and cancellation enables adjacent transmitting and receiving sub-arrays to operate simultaneously in the same frequency band without a significant reduction in performance. Our approach uses only digital signal...

READ MORE

Scalable prototyping testbed for MMW imager system

Published in:
6th Int. Symp. on Phased Array Systems and Technology, PAST 2016, 18-21 October 2016.

Summary

A prototyping testbed for an experimental millimeter-wave multiple-imput multiple-output (MIMO) radar system for security applications in high foot-traffic areas will be presented. The system is designed for flexible operation at a 10 Hz video rate, enabled by high-speed electronic scanning and real-time signal processing. Overall imaging system costs are reduced by the use of an innovative ultra-sparse multistatic radar solution and a 3-D near-field beamforming image construction technique targeted for low-cost high-throughput GPU processors. The testbed is architected with FPGAs, GPUs, CPU storage, and networking, capable of supporting future growth in capabilities, such as interference suppression & advanced signal processing algorithms, auxiliary sensing modalities, near-sensor analytics, and integration into a system-of-systems security architecture.
READ LESS

Summary

A prototyping testbed for an experimental millimeter-wave multiple-imput multiple-output (MIMO) radar system for security applications in high foot-traffic areas will be presented. The system is designed for flexible operation at a 10 Hz video rate, enabled by high-speed electronic scanning and real-time signal processing. Overall imaging system costs are reduced...

READ MORE

HF vector sensor for radio astronomy: ground testing results

Summary

The radio sky below ~10 MHz is largely unexplored due to the inability of ground-based telescopes to observe near or below the ionospheric plasma frequency, or cut-off frequency. A space-based interferometric array is required to probe the portion of the electromagnetic (E-M) spectrum below 10 MHz with sufficient angular resolution and sensitivity to be scientifically useful. Multi-spacecraft constellations scale quickly in cost and complexity as the number of spacecraft increases, so minimizing the number of required spacecraft for an interferometric array (while maintaining performance) is critical for feasibility. We present the HF (High Frequency, 3 to 30 MHz) Vector Sensor as a high performance spacecraft instrument in a future space-based interferometric array. The HF Vector Sensor is composed of three orthogonal dipoles and three orthogonal loop antennas with a common phase center. These six elements fully measure the E-M field of incoming radiation. We present the design of two prototype HF Vector Sensors, ground-based data collection at frequencies above the ionospheric cut-off, and imaging results using several different algorithms.
READ LESS

Summary

The radio sky below ~10 MHz is largely unexplored due to the inability of ground-based telescopes to observe near or below the ionospheric plasma frequency, or cut-off frequency. A space-based interferometric array is required to probe the portion of the electromagnetic (E-M) spectrum below 10 MHz with sufficient angular resolution...

READ MORE