Publications

The Discrete Address Beacon System (DABS) has been designed as an evolutionary replacement for the Air Traffic Control Radar Beacon System (ATCRBS). As with ATCRBS, DABS is a cooperative Air Traffic Surveillance System utilizing ground based sensors (interrogators) and airborne transponders. In addition to its surveillance function, DABS integrally accommodates ground-to-air and air-to-ground data link communication within the interrogations and replies. In DABS, each aircraft transponder may be individually interrogated, using its unique 24-bit address, giving the ground based interrogators freedom to schedule interrogations and replies to make efficient use of the channels essentially independent of the aircraft traffic distribution. The evolutionary constraint on DABS, requiring the capability for one-for-one replacement of ATCRBS ground sensors and transponders, dictated the need to maximize commonality between the two systems. Thus, the ATCRBS interrogation and reply frequencies (1030 and 1090 MHz) were prime candidates for DABS operating frequencies. This report presents the rationale for the selection of the DABS signalling waveforms and error control techniques. The main issues in arriving at the final link design were (1) affordable transponder cost, (2) electromagnetic compatibility with ATCRBS and TACAN, and (3) adequate performance in the channel environment, which includes interference from ATCRBS transmissions. The resulting DABS that of ATCRBS, and transmits ground-to-air data link messages with high reliability. This is accomplished without noticeably affecting ATCRBS performance, with less channel occupancy per target report than ATCRBS, and with transponders projected to cost approximately 160% of the cost of ATCRBS transponders.

One of the major concerns in the DABS development program has been the cost of the DABS transponder. In order to realistically assess the impact on transponder cost of the many alternative techniques and design choices being considered for DABS, four study contracts were awarded to avionics manufacturers to design and estimate costs of special circuitry (in Phase I) and complete transponders (in Phase II). This report summarizes the major results of these design/cost studies, which cover general aviation, military, and air carrier transponder designs (including a retrofit kit for the military APX-72 transponder). The transponder design/cost studies have had a marked influence on the design of the DABS signal and message formats. Since the cost studies were basically intended for comparing link options for DADS, the transponder specifications used in these cost studies do not correspond in detail to current DABS transponder specifications. Therefore the cost data contained in this report cannot be taken to be completely representative of the cost of the finally specified DABS transponders.