Publications

We demonstrate Mach-Zehnder-type interferometry in a superconducting flux qubit. The qubit is a tunable artificial atom, the ground and excited states of which exhibit an avoided crossing. Strongly driving the qubit with harmonic excitation sweeps it through the avoided crossing two times per period. Because the induced Landau-Zener transitions act as coherent beamsplitters, the accumulated phase between transitions, which varies with microwave amplitude, results in quantum interference fringes for n = 1 to 20 photon transitions. The generalization of optical Mach-Zehnder interferometry, performed in qubit phase space, provides an alternative means to manipulate and characterize the qubit in the strongly driven regime.

III-N materials currently enjoy a predominant role in the formation of solid-state light emitters for [lamda]

An entry level overview of state-of-the-art CMOS detector technology is presented. Operating principles and system architecture are explained in comparison to the well-established CCD technology, followed by a discussion of important benefits of modern CMOS-based detector arrays. A number of unique CMOS features including different shutter modes and scanning concepts are described. In addition, sub-field stitching is presented as a technique for producing very large imagers. After a brief introduction to the concept of monolithic CMOS sensors, hybrid detectors technology is introduced. A comparison of noise reduction methods for CMOS hybrids is presented. The final sections review CMOS fabrication processes for monolithic and vertically integrated image sensors.

A taxonomy that uses twenty-two attributes to characterize C-program overflows was used to construct 291 small C-program test cases that can be used to diagnostically determine the basic capabilities of static and dynamic analysis buffer overflow detection tools. Attributes in the taxonomy include the buffer location (e.g. stack, heap, data region, BSS, shared memory); scope difference between buffer allocation and access; index, pointer, and alias complexity when addressing buffer elements; complexity of the control flow and loop structure surrounding the overflow; type of container the buffer is within (e.g. structure, union, array); whether the overflow is caused by a signed/unsigned type error; the overflow magnitude and direction; and whether the overflow is discrete or continuous. As an example, the 291 test cases were used to measure the detection, false alarm, and confusion rates of five static analysis tools. They reveal specific strengths and limitations of tools and suggest directions for improvements.

Range-velocity (RV) ambiguity is a source of data quality degradation common to all weather radars. Various methods have been developed in recent years to combat this problem. For example, for the new NEXRAD Open Radar Data Acquisition (ORDA) system, the primary focus for range-overlay separation has been on phase-code transmission and processing techniques. There are, however, conditions under which the phase-code method fails to separate range-overlaid signals, e.g., when the overlaid power ratio is too high or the Doppler spectra are too wide. Phase-code processing also has no intrinsic capacity for velocity dealiasing. To address these issues, Lincoln Laboratory developed an alternative RV ambiguity mitigation scheme using multiple pulse-repetition interval (multi-PRI) transmission and processing. The range-dealiasing performance of the multi-PRI approach complements the capability of the phase-code technique. It can succeed when phase-code processing fails, and where it fails, phase-code processing succeeds (e.g., when an overlaid patch of signal is continuous and extensive in the radial direction). Multi-PRI also provides velocity dealiasing. However, because the multi-PRI algorithm was constructed for the Terminal Doppler Weather Radar (TDWR) with its primary mission of short-range coverage around airports, only the capability of first-trip protection was explicitly developed. This report extends the multi-PRI technique to the recovery of Doppler data from other trips, out to the long-range surveillance limit of NEXRAD. Simulated and real weather radar data are used to demonstrate the capabilities and limitations of the technique.

This paper discusses inter-related studies and development activities that address the significant challenges of implementing Air Traffic Management initiatives in airspace impacted by thunderstorms. We briefly describe current thrusts that will improve the quality and precision of thunderstorm forecasts, work in progress to convert these forecasts into estimates of future airspace capacity, and an initiative to develop a robust ATM optimization model based on future capacity estimates with associated uncertainty bounds. We conclude with a discussion of the thunderstorm ATM problem in the context of future advanced airspace management concepts.

As part of a broader FAA program to improve supportability, the Terminal Doppler Weather Radar (TDWR) radar data acquisition (RDA) subsystem is being replaced. For this purpose we developed an engineering prototype RDA with a scalable, open-systems hardware platform. This paper describes the design and characteristics of this new system. The dramatically increased computing power and more flexible transmitter control also enables modern signal processing algorithms to be implemented to improve the quality of the base data. Results highlighting the improved range-overlay protection provided by the new algorithms are presented.

This paper is a concept study for possible future utilization of active electronically scanned radars to provide weather and aircraft surveillance functions in U.S. airspace. If critical technology costs decrease sufficiently, multi-function phased array radars might prove to be a cost effective alternative to current surveillance radars, since the number of required radars would be reduced, and maintenance and logistics infrastructure would be consolidated. A radar configuration that provides terminal-area and long-range aircraft surveillance and weather measurement capability is described and a radar network design that replicates or exceeds current airspace coverage is presented. Key technology issues are examined, including transmit-receive elements, overlapped sub-arrays, the digital beamformer, and weather and aircraft post-processing algorithms. We conclude by discussing implications relative to future national weather and non-cooperative aircraft target surveillance needs. The U.S. Government currently operates four separate ground based surveillance radar networks supporting public and aviation-specific weather warnings and advisories, and primary or "skin paint" aircraft surveillance. The separate networks are: (i) The 10-cm wavelength NEXRAD or WSR88-D (Serafin and Wilson, 2000) national-scale weather radar network. This is managed jointly by the National Weather Service (NWS), the Federal Aviation Administration (FAA), and the Department of Defense (DoD). (ii) The 5-cm wavelength Terminal Doppler Weather Radars (TDWR) (Evans and Turnbull, 1989) deployed at large airports to detect low-altitude wind-shear phenomena. (iii) The 10-cm wavelength Airport Surveillance Radars (ASR-9 and ASR-11) (Taylor and Brunins, 1985) providing terminal area primary aircraft surveillance and vertically averaged precipitation reflectivity measurements. (iv) The 30-cm wavelength Air Route Surveillance Radars (ARSR-1, 2, 3 and 4) (Weber, 2005) that provide national-scale primary aircraft surveillance. The latter three networks are managed primarily by the FAA, although the DoD operates a limited number of ASRs and has partial responsibility for maintenance of the ARSR network. In total there are 513 of these radars in the contiguous United States (CONUS), Alaska, and Hawaii. The agencies that maintain these radars conduct various "life extension" activities that are projected to extend their operational life to approximately 2020. At this time, there are no defined programs to acquire replacement radars. The NWS and FAA have recently begun exploratory research on the capabilities and technology issues related to the use of multi-function phased array radar (MPAR) as a possible replacement approach. A key concept is that the MPAR network could provide both weather and primary aircraft surveillance, thereby reducing the total number of ground-based radars. In addition, MPAR surveillance capabilities would likely exceed those of current operational radars, for example, by providing more frequent weather volume scans and by providing vertical resolution and height estimates for primary aircraft targets. Table 1 summarizes the capabilities of current U.S. surveillance radars. These are approximations and do not fully capture variations in capability as a function, for example, of range or operating mode. A key observation is that significant variation in update rates between the aircraft and weather surveillance functions are currently achieved by using fundamentally different antenna patterns--low-gain vertical "fan beams" for aircraft surveillance that are scanned in azimuth only, versus high-gain weather radar "pencil beams" that are scanned volumetrically at much lower update rates. Note also that, if expressed in consistent units, the power-aperture products of the weather radars significantly exceed those of the ASRs and ARSRs. In the next section, we present a concept design for MPAR and demonstrate that it can simultaneously provide the measurement capabilities summarized in Table 1. In Section 3 we present an MPAR network concept that duplicates the airspace coverage provided by the current multiple radar networks. Section 4 discusses technology issues and associated cost considerations. We conclude in Section 5 by discussing implications relative to future national weather and non-cooperative aircraft target surveillance needs.

Over a decade ago the FAA identified a need to detect and forecast movement of wind shear hazards such as gust fronts that impact the terminal air space. The Machine Intelligent Gust Front Algorithm (MIGFA) was developed to address this need (Delanoy and Troxel, 1993). The MIGFA product provides the position, the forecasted positions, and the strength of each wind shear detection to support air traffic control safety and planning functions. MIGFA will realize a new capability for NEXRAD but was originated for use with the FAA's Airport Surveillance Radar Model 9 (ASR-9) Weather Systems Processor (WSP) as described in Troxel and Pughe (2002). Subsequently, a second version was developed for the FAA's Terminal Doppler Weather Radar (TDWR) and is a component of the FAA's Integrated Terminal Weather System (ITWS). Most of the larger U.S. airports have ITWS installations. The ASR-9s are associated with medium-sized airports. MIGFA in NEXRAD is intended to further expand MIGFA support of air traffic control functions. There are significant algorithmic differences between the ASR-9 WSP and TDWR versions of MIGFA, primarily because of the different beam types of the two radars. Physically, the TDWR's pencil beam allows for good vertical resolution in a spatial volume of data. The ASR-9's vertical fan beam results in poor vertical resolution. Nonetheless, a key tenet in developing these two versions of MIGFA was to use the same core image processing analysis techniques (Morgan and Troxel, 2002) central to the MIGFA functionality. This same core is also central to MIGFA in NEXRAD. The Massachusetts Institute of Technology's Lincoln Laboratory (LL) has been tasked by the FAA to transfer MIGFA technology to NEXRAD. The goal is to enable a NEXRAD MIGFA capability at airports within about 70 km of any NEXRAD. LL has been developing NEXRAD algorithms to address the FAA's weather systems' needs since the Open Radar Product Generator (ORPG) was fielded in 2001. FAA sponsored, LL-developed NEXRAD algorithms generate the following products: the Data Quality Assurance (DQA), the High Resolution VIL (HRVIL), and the High Resolution Enhanced Echo Tops (HREET) (Smalley et al., 2003). These algorithms have proven useful to non-FAA users of NEXRAD products such as the National Weather Service (NWS) and the Department of Defense (DoD). Similarly, the NWS and DoD are developing plans to use MIGFA. MIGFA is slated to be included in the ORPG Build 9 baseline that is scheduled to be released in the Spring of 2007. In the following sections, we will discuss the salient features of MIGFA; the tuning of MIGFA to NEXRAD data; a comparison of detection performance of the TDWR and NEXRAD MIGFA versions; and some examples of MIGFA in operation.

A radar data quality control (QC) system is being developed for the real-time, continuously updateable NOWCAST system at the Naval Research Laboratory (NRL-NOWCAST) in Monterey, California. NRL has developed its own new radar QC algorithms, and is also working with the MIT Lincoln Laboratory (MIT LL), the National Center for Atmospheric Research (NCAR), the National Severe Storms Laboratory and the Cooperative Institute for Mesoscale Meteorological Studies at the University of Oklahoma (NSSL-OU) to obtain, adapt, integrate, test and install various types of recently-developed radar QC algorithms for use with NRL-NOWCAST. These algorithms work with volume scans of full-resolution Doppler radar data. Radar data QC can be divided into two categories: echo classification (EC) and calibration. New EC algorithms have recently demonstrated substantial success at separating the radar echoes of precipitation from other echo types, such as noise, normal propagation (NP) and anomalous propagation (AP) ground clutter, sea clutter, insects/clear-air, birds, second-trip echoes, and constant power function (CPF) artifacts. Radar data calibration methods assess the accuracy of both the data values and data coordinates. One calibration issue is aliased radial velocity data from precipitation and insect/clear-air returns, which if correctly de-aliased, afford the opportunity to estimate winds. Another calibration issue of concern to NRL is the processing of radar data from mobile platforms, such as US Navy ships. This processing requires corrections to the radial velocity data and the data-coordinates for the motion of the platform, as well as corrections for the altitude of the data coordinates due to the AP of the radar beam that frequently occurs within surface and evaporation ducts of the marine atmosphere. The goal of this work is to test the performance of the most current and promising radar data QC algorithms on archived data sets, both from ground- and sea-based radars, in order to determine the optimal combination for future real-time use within NRL-NOWCAST. NRL-NOWCAST currently ingests full-resolution Doppler radar data from both the Weather Surveillance Radar-1988 Doppler (WSR-88D) network and the US Department of Defense (DoD) Supplemental Weather Radar (SWR) at the Naval Air Station (NAS) in Fallon, NV. Various products are then created from these data for NRL-NOWCAST display. The radar data are also ingested into the COAMPS-0S (R) (Geiszler et al. 2004) data assimilation system at NRL. Figure 1 shows a flow chart that summarizes the processing stages and uses of radar data at NRL. Figure 2 shows an example of the NRL-NOWCAST demonstration site currently set up at Fallon, where the specific products displayed are only a few from a large list that may be chosen by the forecasters at the NAS. This paper presents a brief overview of the concepts behind the various EC and radial velocity de-aliasing algorithms under consideration. Test results from an NRL algorithm-testing platform will also be presented along with some previously published test results from the authors. Additional test results from the platform will be presented at the conference. Methods to address data-value and data coordinate calibration problems associated with Doppler radars onboard US Navy ships are currently being studied; a discussion on future work in this area will be outlined.