Publications
Adaptive doppler filtering applied to modern air traffic control radars
April 26, 2004
Conference Paper
Published in:
Proc. of the IEEE 2004 Radar Conf., 26-29 April 2004, pp. 242-248.
Topic:
R&D area:
R&D group:
Summary
This paper presents an analysis of the Doppler processing technology currently in use in the nation's terminal airport surveillance radars, and examines possibilities for performance improvement, particularly in the presence of moving clutter. The research focuses on five- and eight-pulse waveform methodologies and their respective detection capabilities given clearly defined rain clutter scenarios. Performance with fixed coefficient filters similar to those used in the existing radars is calculated, followed by performance using an adaptive Doppler filtering technique. Performance is quantified in terms of signal-to-interference ratio at the output of the Doppler filters and resultant probability of detection given a specified probability of false alarm. The results will show that a substantial improvement in detection in the vicinity of rain clutter is realized for both the five- and eight-pulse waveforms when using the adaptive coefficient Doppler filters as compared to the performance observed with the fixed coefficient filters. For constant filter weights, the eight-pulse Doppler filters give significantly better performance in most diverse rain clutter than the five-pulse Doppler filters.
Summary
This paper presents an analysis of the Doppler processing technology currently in use in the nation's terminal airport surveillance radars, and examines possibilities for performance improvement, particularly in the presence of moving clutter. The research focuses on five- and eight-pulse waveform methodologies and their respective detection capabilities given clearly defined...
READ MORE
Power-law scattering models and nonlinear parametric estimation for super-resolution radar
April 26, 2004
Technical Report
Published in:
MIT Lincoln Laboratory Report TR-1095
Topic:
R&D group:
Summary
This paper introduces a direct solution of the frequency-dependent, GTD-based, scatterer-model parameters leading towards a new modern spectral-estimation technique to be used for enhanced, super-resolution radar analysis. The overcomplete nature of the full GTD scatterer-model basis (positive and negative half-integer power laws) is recognized and overcome by introducing the vector-channel method, well known from communication theory. This physically motivated discretemodel- based analysis eliminates the need for computationally intensive and potentially nonconvergent local optimization procedures. Each scatterer is assigned a half-integer power law that identifies its cross-section frequency dependence and hence restricts the possible underlying physical feature geometries. This analysis opens the possibility for vector-attribute-based feature processing for target recognition that offers the potential for significant improvement in target identification performance.
Summary
This paper introduces a direct solution of the frequency-dependent, GTD-based, scatterer-model parameters leading towards a new modern spectral-estimation technique to be used for enhanced, super-resolution radar analysis. The overcomplete nature of the full GTD scatterer-model basis (positive and negative half-integer power laws) is recognized and overcome by introducing the vector-channel...
READ MORE
A method for correcting Fourier transform spectrometer (FTS) dynamic alignment errors
April 12, 2004
Conference Paper
Published in:
SPIE Vol. 5425, Algorithms and Technologies for Multispectral, Hyperspectral, and Ultraspectral Imagery X, 12-15 April 2004, pp. 443-455.
Summary
The Cross-track Infrared Sounder (CrIS), like most Fourier Transform spectrometers, can be sensitive to mechanical disturbances during the time spectral data is collected. The Michelson interferometer within the spectrometer modulates input radiation at a frequency equal to the product of the wavenumber of the radiation and the constant optical path difference (OPD) velocity associated with the moving mirror. The modulation efficiency depends on the angular alignment of the two wavefronts exiting the spectrometer. Mechanical disturbances can cause errors in the alignment of the wavefronts which manifest as noise in the spectrum. To mitigate these affects CrIS will employ a laser to monitor alignment and dynamically correct the errors. Additionally, a vibration isolation system will damp disturbances imparted to the sensor from the spacecraft. Despite these efforts, residual noise may remain under certain conditions. Through simulation of CrIS data, we demonstrated an algorithmic technique to correct residual dynamic alignment errors. The technique requires only the time-dependent wavefront angle, sampled coincidentally with the interferogram, and the second derivative of the erroneous interferogram as inputs to compute the correction. The technique can function with raw interferograms on board the spacecraft, or with decimated interferograms on the ground. We were able to reduce the dynamic alignment noise by approximately a factor of ten in both cases. Performing the correction on the ground would require an increase in data rate of 1-2% over what is currently planned, in the form of 8-bit digitized angle data.
Summary
The Cross-track Infrared Sounder (CrIS), like most Fourier Transform spectrometers, can be sensitive to mechanical disturbances during the time spectral data is collected. The Michelson interferometer within the spectrometer modulates input radiation at a frequency equal to the product of the wavenumber of the radiation and the constant optical path...
READ MORE
Hyperspectral environmental suite for the Geostationary Operational Environmental Satellite (GOES)
April 12, 2004
Conference Paper
Published in:
SPIE Vol. 5425, Algorithms and Technologies for Multispectral, Hyperspectral, and Ultraspectral Imagery X, 12-15 April 2004, pp. 329-340.
Summary
The GOES satellites will fly a Hyperspectral Environmental Suite (HES) on GOES-R in the 2012 timeframe. The approximately 1500 spectral channels (technically ultraspectral), leading to improved vertical resolution, and approximately five times faster coverage rate planned for the sounder in this suite will greatly exceed the capabilities of the current GOES series instrument with its 18 spectral channels. In the GOES-R timeframe, frequent measurements afforded by geostationary orbits will be critical for numerical weather prediction models. Since the current GOES soundings are assimilated into numerical weather prediction models to improve the validity of model outputs, particularly in areas with little radiosonde coverage, this hyperspectral capability in the thermal infrared will significantly improve sounding performance for weather prediction in the western hemisphere, while providing and enhancing other products. Finer spatial resolution is planned for mesoscale observation of water vapor variations. The improvements over the previous GOES sounders and a primary difference from other planned instruments stem from two-dimensional focal plane array availability. These carry an additional set of challenges in terms of instrument specifications, which will be discussed. As a suite, HES is planned with new capabilities for coastal ocean coverage with the goal of including open ocean coverage. These new planned imaging applications, which will be either multispectral or hyperspectral, will also be discussed.
Summary
The GOES satellites will fly a Hyperspectral Environmental Suite (HES) on GOES-R in the 2012 timeframe. The approximately 1500 spectral channels (technically ultraspectral), leading to improved vertical resolution, and approximately five times faster coverage rate planned for the sounder in this suite will greatly exceed the capabilities of the current...
READ MORE
InGaAsP/InP quantum-well electrorefractive modulators with sub-volt V[pi]
April 12, 2004
Conference Paper
Published in:
SPIE Vol. 5435, Enabling Photonic Technologies for Aerospace Applications VI, 12-16 April 2004, pp. 53-63.
Topic:
R&D area:
Summary
Advanced analog-optical sensor, signal processing and communication systems could benefit significantly from wideband (DC to > 50 GHz) optical modulators having both low half-wave voltage (V[pi]) and low optical insertion loss. An important figure-of-merit for modulators used in analog applications is TMAX/V[pi], where TMAX is the optical transmission of the modulator when biased for maximum transmission. Candidate electro-optic materials for realizing these modulators include lithium niobate (LiNbO3), polymers, and semiconductors, each of which has its own set of advantages and disadvantages. In this paper, we report the development of 1.5-um-wavelength Mach-Zehnder modulators utilizing the electrorefractive effect in InGaAsP/InP symmetric, uncoupled semiconductor quantum-wells. Modulators with 1-cm-long, lumped-element electrodes are found to have a push-pull V[pi] of 0.9V (V[pi]L = 9 V-mm) and 18-dB fiber-to-fiber insertion loss (TMAX/V[pi] = 0.018). Fabry-Perot cutback measurements reveal a waveguide propagation loss of 7 dB/cm and a waveguide-to-fiber coupling loss of 5 dB/facet. The relatively high propagation loss results from a combination of below-bandedge absorption and scattering due to waveguide-sidewall roughness. Analyses show that most of the coupling loss can be eliminated though the use of monolithically integrated invertedtaper optical-mode converters, thereby allowing these modulators to exceed the performance of commercial LiNbO3 modulators (TMAX/V[pi] ~ 0.1). We also report the analog modulation characteristics of these modulators.
Summary
Advanced analog-optical sensor, signal processing and communication systems could benefit significantly from wideband (DC to > 50 GHz) optical modulators having both low half-wave voltage (V[pi]) and low optical insertion loss. An important figure-of-merit for modulators used in analog applications is TMAX/V[pi], where TMAX is the optical transmission of the...
READ MORE
Corridor Integrated Weather System operation benefits 2002-2003 : initial estimates of convective weather delay reduction
April 9, 2004
Project Report
Published in:
MIT Lincoln Laboratory Report ATC-313
Summary
The Corridor Integrated Weather System (CIWS) seeks to improve safety and reduce delay by providing accurate, automated, rapidly updated information on storm locations and echo tops along with two-hour high-resolution animated growth and decay convective storm forecasts. An operational benefits assessment was conducted using on-site observations of CIWS usage at major en route control centers in the Northeast and Great Lakes corridors and the Air Traffic Control Systems Command Center (ATCSCC) during six multi-day periods in 2003. This first phase of the benefit assessment characterizes major safety and delay reduction benefits and quantifies the delay reduction benefits for two key Traffic Flow Management (TFM) user benefits: "keeping air routes open longer/reopening closed routes soon" and "proactive, efficient reroutes of traffic around storm cells." The overall CIWS delay reduction for these two benefits is 40,000 to 69,000 hours annually with an equivalent monetary value ot $127M to $26M annually. Convective weather delays at most of the major airports in the test domain, normalized by thunderstorm frequency, decreased after new CIWS echo tops and forecast products were introduced. Recommendations are made for near-term, low-cost improvements to the CIWS demonstration system to further increase the operational benefits.
Summary
The Corridor Integrated Weather System (CIWS) seeks to improve safety and reduce delay by providing accurate, automated, rapidly updated information on storm locations and echo tops along with two-hour high-resolution animated growth and decay convective storm forecasts. An operational benefits assessment was conducted using on-site observations of CIWS usage at...
READ MORE
A tutorial on text-independent speaker verification
April 1, 2004
Journal Article
Published in:
EURASIP J. on Appl. Sig. Proc., Vol. 4, 1 April 2004, pp. 430-451.
Topic:
R&D area:
Summary
This paper presents an overview of a state-of-the-art text-independent speaker verification system. First, an introduction proposes a modular scheme of the training and test phases of a speaker verification system. Then, the most commonly speech parameterization used in speaker verification, namely, cepstral analysis, is detailed. Gaussian mixture modeling, which is the speaker modeling technique used in most systems, is then explained. A few speaker modeling alternatives, namely, neural networks and support vector machines, are mentioned. Normalization of scores is then explained, as this is a very important step to deal with real-world data. The evaluation of a speaker verification system is then detailed, and the detection error trade-off (DET) curve is explained. Several extensions of speaker verification are then enumerated, including speaker tracking and segmentation by speakers. Then, some applications of speaker verification are proposed, including on-site applications, remote applications, applications relative to structuring audio information, and games. Issues concerning the forensic area are then recalled, as we believe it is very important to inform people about the actual performance and limitations of speaker verification systems. This paper concludes by giving a few research trends in speaker verification for the next couple of years.
Summary
This paper presents an overview of a state-of-the-art text-independent speaker verification system. First, an introduction proposes a modular scheme of the training and test phases of a speaker verification system. Then, the most commonly speech parameterization used in speaker verification, namely, cepstral analysis, is detailed. Gaussian mixture modeling, which is...
READ MORE
Photoresist outgassing: a potential Achilles heel for short wavelength optical lithography?
February 22, 2004
Conference Paper
Published in:
SPIE Vol. 5376, Advances in Resist Technology and Processing XXI, 22-27 February 2004, pp. 1-15.
Summary
The outgassing of volatile organic compounds during photoresist exposure at short wavelengths (
Summary
The outgassing of volatile organic compounds during photoresist exposure at short wavelengths (
READ MORE
Analysis of multitarget detection for speaker and language recognition
January 1, 2004
Conference Paper
Published in:
ODYSSEY 2004, 31 May-4 June 2004.
Topic:
R&D area:
Summary
The general multitarget detection (or open-set identification) task is the intersection of the more common tasks of close-set identification and open-set verification/detection. In this task, a bank of parallel detectors process an input and must decide if the input is from one of the target classes and, if so, which one (or a small set containing the true one). In this paper, we analyze theoretically and empirically the behavior of a multitarget detector and relate the identification confusion error and the miss and false alarm detection errors in predicting performance. We show analytically that the performance of a multitarget detector can be predicted from single detector performance using speaker and language recognition data and experiments.
Summary
The general multitarget detection (or open-set identification) task is the intersection of the more common tasks of close-set identification and open-set verification/detection. In this task, a bank of parallel detectors process an input and must decide if the input is from one of the target classes and, if so, which...
READ MORE
Automated lip-reading for improved speech intelligibility
January 1, 2004
Conference Paper
Published in:
Proc. of the IEEE Int. Conf. on Acoustics, Speech, and Signal Processing, ICASSP, Vol. I, 17-21 May 2004, pp. I-701 - I-704.
Topic:
R&D area:
Summary
Various psycho-acoustical experiments have concluded that visual features strongly affect the perception of speech. This contribution is most pronounced in noisy environments where the intelligibility of audio-only speech is quickly degraded. An exploration of the effectiveness for extracted visual features such as lip height and width for improving speech intelligibility in noisy environments is provided in this paper. The intelligibility content of these extracted visual features will be investigated through an intelligibility test on an animated rendition of the video generated from the extracted visual features, as well as on the original video. These experiments demonstrate that the extracted video features do contain important aspects of intelligibility that may be utilized in augmenting speech enhancement and coding applications. Alternatively, these extracted visual features can be transmitted in a bandwidth effective way to augment speech coders.
Summary
Various psycho-acoustical experiments have concluded that visual features strongly affect the perception of speech. This contribution is most pronounced in noisy environments where the intelligibility of audio-only speech is quickly degraded. An exploration of the effectiveness for extracted visual features such as lip height and width for improving speech intelligibility...
READ MORE